splices in reinforced concrete column-type specimens under high-intensity flexural cyclic loads are presented. This investigation is the fourth phase of a continuing investigation into the behavior and design of lapped splices in reinforced concrete members subjected to seismic loading.

Surface hydrophobicity of actomyosin in 0.6 M NaCl increased with increasing ultrasonic intensity and exposure time to a higher degree than that in 0.2 M NaCl. A greater absolute value of the zeta potential of actomyosin subjected to HIU were also observed. The HIU treatments decreased the turbidity of actomyosin incubated at 40 and 60 °C.

2 During the Tangshan earthquake, some high-intensity anomalies formed in the area. 3 Peng Yanju 4 conducted a seismic response analysis on a Tianjin coastal so soil site and found that the so ...

A molecular dynamics (MD) scheme is combined with a distributed circuit model for a self-consistent analysis of the transient membrane response for cells subjected to an ultrashort (nanosecond) high-intensity (approximately 0.01-V/nm spatially averaged field) voltage pulse. The dynamical, stochastic …

Time dependent details of nanopore formation at cell membranes in response to a high-intensity (100 kV/cm), ultrashort (10 ns) electric pulse are also probed. Our results show that nanosized pores ...

High-intensity eccentric exercise can cause a delayed onset of muscle soreness (DOMS), a short-term condition characterized by muscle damage and tenderness that might hold up recovery and jeopardize exercise routine. ... (20 minutes per day for 7 days) on inflammatory markers (including neutrophil dynamics and function) in active …

The present study is concerned with the numerical analysis of the non-Fourier heat transfer phenomena in biological tissue samples subjected to high intensity focused ultrasound (HIFU). Due to the inherent non-homogeneous nature of biological samples, the well-known Pennes bioheat equation (PBHTE) is not strictly suitable for correctly ...

The influence of mandibular stretching on athletes subjected to high intensity workout Arch Ital Biol. 2022 Jan 25;159(3-4):178-186. doi: 10.12871 ... performance time in a high-intensity workout measured before and after seven days of 10-minutes stretching practiced twice daily, while no improvement was observed in control …

When ultrasonic stimulation is applied to plant seeds it may promote the development of new adaptive characteristics during germination, thus providing an alternative to regulate nutritional and physicochemical attributes of germinated seeds. However, there is rather limited information concerning high-intensity ultrasound (HIU) …

Cited by. Year. Self-consistent simulations of electroporation dynamics in biological cells subjected to ultrashort electrical pulses. RP Joshi, Q Hu, R Aly, KH bach, HP Hjalmarson. Physical Review E 64 (1), 011913., 2001. 239. 2001. Simulations of transient membrane behavior in cells subjected to a high-intensity ultrashort electric pulse.

Request PDF | Damage Evolution Modeling for Steel Structures Subjected to Combined High Cycle Fatigue and High-Intensity Dynamic Loadings | This paper presents a method for modeling the initiation ...

Time-of-flight mass spectrometry of aromatic molecules subjected to high intensity laser beams

To address this gap, the seismic responses of super high-rise buildings ranging in height from 400 m to 800 m are investigated when subjected to LPGMs. The effectiveness of earthquake intensity measures, which serve as indices connecting seismic hazards to structural responses, is evaluated in capturing the seismic effects caused by …

Characterizing physicochemical, nutritional and quality attributes of wholegrain Oryza sativa L. subjected to high intensity ultrasound-stimulated pre-germination Author links open overlay panel Qiang Xia a b, Hong Tao b, Yunfei Li b, Daodong Pan a, Jinxuan Cao a, Lianliang Liu a, Xiaowei Zhou c d, Francisco J. Barba e

The study reveals that using ideal-gas based fluid–structure-interaction models in predicting high-intensity air-blast loads on sandwich panels leads to an under-prediction in core compression and plastic dissipation for the same "crushing strength to incident over-pressure ratio."

This paper investigates the overload capabilities and damage mechanisms of Glass Fiber Reinforced Polymer (GFRP) bar reinforced concrete beams subject to high-intensity low-velocity impact loads. The overload condition of the beam is defined as the …

The transient vortex dynamics within a microsecond-level acoustic cycle were numerically investigated when an orifice–cavity structure, which is a unit …

A tower may be subjected to earthquake loads which could be of high intensity (event H) or of long period (event L). It is estimated if the load has long duration, the probability that its intensity is high is 0.7. Also, if the load has high intensity, the probability that its duration is long is 0.8. Finally, the probability of having a long ...

Robust features of a turbulent boundary layer subjected to high-intensity free-stream turbulence. R. J. Hearst, E. Dogan, B. Ganapathisubramani. Published in …

The present work is concerned with the numerical investigation of the thermal response of tissue-mimicking biological phantom(s) subjected to high intensity focused ultrasound …

Note: Control: untreated MPS; HIU: MPS subjected to high-intensity ultrasound treatment; HPP: MPS subjected to high-pressure processing; HPH: MPS subjected to high-pressure homogenization. 3.4. Gel strength. Gel strength is an essential mechanical indicator of the textural properties of gels.

Article history. Share. Tools. Dynamics of cavitation microbubbles due to high intensity ultrasound are associated with important applications in biomedical ultrasound, …

Kistler-Fischbacher et al. used a high cut-off for high-intensity exercises, wherein resistance training at >80% one-repetition maximum (1-RM) in sets of six or fewer repetitions, and impact training, creating a ground reaction force (GRF) of four times the body weight were selected, which led to fewer studies in the high-intensity category .

a. the high-intensity spark cleans the igniter. b. the frequency of the spark is less for igniters. c. turbine igniters operate at cooler temperatures. a. the high-intensity spark cleans the igniter. (8557) The constrained-gap igniter plug used in some gas turbine engines operates at a cooler temperature because.

The experiments were designed in order to test performance under both steady, low-intensity rainfall, as well as under short duration, high-intensity rainfall conditions. A control membrane roof and prototype green roofs of 2.5-, 6.3-, 10.1-cm depths were subjected to simulated precipitation in a laboratory setting.

High-intensity ultrasound assisted food processing is a promising and emerging non-thermal method, having broad applications in various food processing operations such as homogenization ...

However, few studies have investigated the thermoregulatory adaptations induced by high-intensity interval training (HIIT) protocols. Thus, the present study aimed to compare the adaptations in rats' thermoregulatory parameters and aerobic performance observed after two different heat acclimation regimens consisting of HIIT protocols …

DOI: 10.1016/J.SOILDYN.2016.03.008 Corpus ID: 130705152; Challenges associated with site response analyses for soft soils subjected to high-intensity input ground motions @article{Griffiths2016ChallengesAW, title={Challenges associated with site response analyses for soft soils subjected to high-intensity input ground motions}, …

the high-intensity spark cleans the igniter. The constrained-gap igniter plug used in some gas turbine engine operates at a cooler temperature because. ... Igniter plugs used in turbine engines are subjected to high intensity spark discharges and yet they have a long service life because they.

Nonlinear site response analyses are generally preferred over equivalent linear analyses for soft soil sites subjected to high-intensity input ground motions. However, both nonlinear (NL) and equivalent linear (EQL) analyses often result in large shear strain estimates (3–10%) at soft sites, and these large strains may generate …